Site Map

 







New Search:
 
Ibcinyou RC
p.o. box 432044
St. Louis, Missouri  63143

314-256-9987

NOW on Facebook

 

Pay-Pal
RCU, RC Groups
Flying Giants Member
 
                                                                             
          
   NEW release RCGF 
       70cc Twin        
Falcon Carbon Fiber & Beechwood Props
 
RAGE Spirit of St. Louis 
Micro RTF Aircraft  


 

 

Ibcinyou r/c > Servos: Futaba, JR/DFA, Savox, MKS, Hitec, SWB Products > JR Servos > Specialty Air > JR Aluminum HD Single Servo Arm 2"

$18.99

Temporarily out of stock

JR Aluminum HD Single Servo Arm 2"

Overview

JR - JRPA05025 - Aluminum HD Single Servo Arm 2"

A stylish way to add functionality to your aircraft!

Servo arms are a critical, yet often overlooked, component of an aircraft's setup. They are a component that is often selected at the last moment in an aircraft's assembly, however are quick to receiveblame any time there is loss of control of the aircraft.

A quick glance at these arms reveals beautiful execution of a very simple item, but once you get past the stunning blue anodized skin,the attention to detail becomes quite visible. Each arm is carefullymachined from the highest quality aluminum bar stock to the tightest of tolerances. They are much thicker than typical aluminum servo arms for better shear and tensional strength. The hubs are eventhicker than the arms for maximum strength and surface contact withthe servo's output gear. Also a unique feature to the hubs is the secure, locking clamp design that will tighten to your servo to virtually eliminate any mechanical slop, yet release for easy removal from the servo with no tools, scraped knuckles, bent arms, or bad wordsuttered.

Polished, bevel-cut edges and laser-engraved JR logo add the finishing touches to the arms and give an appearance that is several levels above anything else in the market with performance to match.Try a set out on your new project. We're sure you'll feel the difference!

Features

JR - JRPA05025 - Aluminum HD Single Servo Arm 2"
Machined from the highest quality aluminum bar stock.
Thicker design with reinforced center for maximum strength in critical applications such as hard 3D with giant scale airplanes
Unique locking clamp design locks onto servo output shaft with zero slop, yet allows for easy removal
Anodized turquoise for beautiful appearance, and protection from oxidization.
Polished, beveled corners relieve stress risers resulting in higher strength and better appearance

Image 0 of JR Aluminum HD Single Servo Arm 2


Image 1 of JR Aluminum HD Single Servo Arm 2


      

 

Build your own web store with PrestoStore