Site Map


New Search:
Ibcinyou RC
p.o. box 432044
St. Louis, Missouri  63143


NOW on Facebook


RCU, RC Groups
Flying Giants Member
   NEW release RCGF 
       70cc Twin        
Falcon Carbon Fiber & Beechwood Props
RAGE Spirit of St. Louis 
Micro RTF Aircraft  



Ibcinyou r/c > Servos: Futaba, JR/DFA, Savox, MKS, Hitec, SWB Products > JR Servos > Specialty Air > JR Z9100HVS High Voltage Ultra Speed Servo


Temporarily out of stock

JR Z9100HVS High Voltage Ultra Speed Servo


JR - JRPSZ9100HVS - Z9100HVS High Voltage Ultra Speed Servo
With its all aluminum case, SuperSteel gears, a high voltage motor and improved electronics, the Z9100HVS takes on, or offroad racing to a whole new level of confidence. Plus it maintains JR's legendary reliability and unmatched, true zero-deadband precision.

Battery chemistries such as LiPo, LiIon, and LiFe have become very popular within the RC community. They are the standard for powering electric motors and have also gained popularity as receiver battery packs. The issue is the output voltage of these batteries is higher then the previous standard 4 - and 5-cell NiCd and NiMH packs, 4.8V and 6V respectively. The higher voltage is not an issue with the receivers but can be for the servos. Many servos will not operate at these higher voltages for very long before burning out the motors or electronics.

To get around this issue modelers have had to use a regulator to drop the voltage to an acceptable operating range for their servos, usually around 5 to 6 volts. The addition of a regulator adds a component that, should it fail, can cause the loss of a model.

JR's HV servos are designed with motors and electronics that operate off the direct voltage of a 2-cell LiPo, LiIon, or LiFe receiver battery pack (6.6V to 7.4V nominal voltage). This eliminates the need for a regulator and lowers the chance for a power failure that can cause a catastrophic failure of your model. Also note that the HV servo specs are shown at the higher voltage (7.4V 2S LiPo) but will still operate on a standard 5-cell 6V NiCd, Ni MH battery with a reduction in performance of approximately 10% in speed and torque.


JR - JRPSZ9100HVS - Z9100HVS High Voltage Ultra Speed Servo
Rugged new aluminum case
JR SuperSteel gears for high precision, long wear
Exclusive motor designed for high voltage applications
Outstanding precision combined with outlandish performance


JR - JRPSZ9100HVS - Z9100HVS High Voltage Ultra Speed Servo
Size Category: Standard
Type: Digital
Application: 1/8, 1/5 on road, off-road surface vehicles, throttle control
Torque: 230 oz/in (2S Li-Po)
Speed: .06 sec/60 (2S Li-Po)
Length: 1.58 in
Width: 0.82 in
Height: 1.57 in
Weight: 2.6 oz
Bushing Or Bearing: Bearing
Bearing: Dual
Motor Type: Coreless
Connector Type: JR
Gear Type: Metal
Gear Material: SuperSteel
Voltage: 7.4V (2S Li-Po)
Deadband: Surface optimized

Image 0 of JR Z9100HVS High Voltage Ultra Speed Servo



Build your own web store with PrestoStore