MPI Voltage Regulator MK3 for Lithium packs

MPI ACC135 Voltage Regulator MK3

Have a question?

Add to Shopping Cart

Large heat sink for optimum performance, Dual HD AWG22 input/
ouput connectors to double current capacity and redundancy,
Output is factory preset to 5.95V, fully adjustable between 5V to
6.5V, When input is higher than 6V or any set voltage, it will regulate
to 6V or any set voltage, When input drops below set voltage,
regulator is bypassed, Weight only 1.4 oz, Current: 10 Amp continuous,
20 Amp 1 minute @ 7.4V input & 6V ouput, Input Range:
4.8V -12V.
Special note: Two Rx packs can be connected this unit. However,
the two packs must be identical in type, capacity, and charge state.
Both packs will be drawn simultaneously for redundancy and load
sharing but this is NOT a backup system.
Note: Current capacity drops as input voltage increases.